WebWalkingEvent; Terminated! Exceeded attempt threshold.

[anderiel]

Hey guys, im getting this log from the client : WebWalkingEvent; Terminated! Exceeded attempt threshold. 

 

Could anyone tell me what it means? It does not happen every time, only for some routes, so maybe it is a bug (i already submitted a bug report thread, but these took way too long to approve and i would like some answers a little bit faster).

 

im using the standard walking.webWalk(Area)

[Eagle Scripts]

Hey guys, im getting this log from the client : WebWalkingEvent; Terminated! Exceeded attempt threshold. 

 

Could anyone tell me what it means? It does not happen every time, only for some routes, so maybe it is a bug (i already submitted a bug report thread, but these took way too long to approve and i would like some answers a little bit faster).

 

im using the standard walking.webWalk(Area)

it probs means that it couldn't find a route, tried as many times until it's threshold and therefore terminated.

 

That's what i'd say looking at the error message, but i'm not sure though

[anderiel]

it probs means that it couldn't find a route, tried as many times until it's threshold and therefore terminated.

 

That's what i'd say looking at the error message, but i'm not sure though

That is not the case, i am quite sure that the route exists. It actually did find it a few times, but most of the time i get this error.

[DragonAlpha]

Try webwalk(Position)

 

You must be passing an Area, and that area contains an unwalkable tile.

 

The webwalker will then fail.

[anderiel]

Try webwalk(Position)

 

You must be passing an Area, and that area contains an unwalkable tile.

 

The webwalker will then fail.

webWalk(Position) gives an unknown metho error, and webWalk(Position[]) when i make and array of one position, gives the same log. Exceeded attempt treshold.

Funny thing is, sometimes after i restart the client, it webwalks just fine. 

[Khaleesi]

webWalk(Position) gives an unknown metho error, and webWalk(Position[]) when i make and array of one position, gives the same log. Exceeded attempt treshold.

Funny thing is, sometimes after i restart the client, it webwalks just fine. 

 

Can You show me the code you are using?

What start position are you using? whats the end position?

Are you installing customInteractingScripts ?

Edited May 17, 2016 by Khaleesi

[anderiel]

Can You show me the code you are using?

What start position are you using? whats the end position?

Are you installing customInteractingScripts ?

Position[] pos = new Position[]{positions[nextLocationIndex]};
        if(walking.webWalk(pos))
        {
// if walking succeeds i change state, else i try walking again.
}

And im going from this area new Area(new Position(2811,3464,0),new Position(2812,3463,0)) to this area new Area(new Position(2668,3377,0),new Position(2673,3372,0))

 

this is the code i tried for using only position, previously i was using webWalk(area) in place of webwalk(position[])

 

and I dont know what customInteractingScripts are.

Edited May 17, 2016 by anderiel